logo

Reduction pvc 1/2 3/8


reduction pvc 1/2 3/8

Harrison Machine Plastic Corporation cannot be held responsible for results.
The primer should be applied to the pipe ends and to an area equal to the corresponding fitting socket depth plus approximately 4 inches.If permitted to remain, grease, oil, ink, etc.At this point, the cement will ooze toward the bottom of the pipe and fill a small section inside the fitting.Tout en surpportant des pressions de service allant jusqu'à 16 bars.Black flexible PVC pipe is only approved for irrigation and pools.All PVC Schedule 80 pipe must also meet the requirements of NSF Standard 14 and CSA Standard B137.3 rigid PVC pipe for pressure applications, and shall bear the mark of these Listing agencies.Do not overbrush the solvent.
Important: It is advisable to utilize two or more pipe fitters.




Align the pipe fitting as close to its final position as possible.The UL rating idée de cadeau pour sa femme forum has been dropped for the Gray m due to lack of demand.Typical allications include: chemical processing, plating, high purity applications, potable water systems, water and wastewater treatment, drainage, irrigation, agricultural, and other applications involving corrosive fluid transfer.The primer will remove the glossy surface, dirt and surface printing.It is imporant that these instructions are carefully followed.0,26HT 0,31 TTC d404676a Ecrou 6 pans en laiton Ø14 F3/4" 0,76HT 0,91 TTC d182105b Ecrous 6 pans F1/2(15/21) D16.Tapered sockets have the capability of providing a fused joint at the socket bottom and a bonded joint at the top of the socket, resulting in a quality seal particularly in pressure applications.



A second coating of primer may then be needed on the pipe to assure wet surfaces Using Gray Medium-Body Cement, liberally apply the solvent, again using a 3" to 4" brush, to both the fitting socket and pipe surface.
Sheet stock material (where used) must conform to astm D-1784, cell classification 12454B, Type 1, Grade 1, normal impact, manufactured without the use of plasticizers or fillers.
Tapered sockets, however, also result in a situation wher ethe pipe will tend to "push-out" immediately after the pipe is inserted into the fitting socket.

[L_RANDNUM-10-999]
Sitemap